Maintenance method of pillow packing machine malfunction

First, when the temperature is too high, the speed is too slow, and the heat resistance of the outer layer of the envelope is poor, the sealing will appear the mark of coke wrinkle. The maintenance method is to adjust the speed, reduce the temperature, and replace the film material.

Two, the knife seat is too high or too low, the packaging speed is too fast, when the push rod and the cutter are not synchronized, the cutter will cut on the product maintenance method is to reduce the packaging speed, adjust the height of the end sealing parts, so that the center of the sealing knife is in the middle of the product height.

3. The color of the film color label is too light, the film drive slips, and the cutting position deviates from the color label when the color label tracking is not turned on. At this time, the maintenance method is to refer to the packaging machine manual and adjust its sensitivity; On the man-machine interface, switch the tracing mode to Tracing Cutting.

Four, solid state breaker burned out, temperature control meter damage, thermocouple damage thermometer can not control the temperature, maintenance method is to replace the electric couple, replace the temperature control meter (see figure on the right), replace the heating element.

Five, the speed is too fast, the inner layer of the envelope heat sealing is poor, the temperature is too low sealing will appear leakage or insecure, maintenance method is to slow down the speed, adjust the temperature, replace the material of the film.

Six, the air pressure is not correct, the cylinder swing rod loosens, the heating temperature is low, the hot pressing roll and the transmission roll are not parallel when there is bad heat sealing, the maintenance method is to adjust the parallelism, adjust the temperature and pressure to make it tight.

And it should be noted that the induction aviation plug must be inserted before the power supply, and lock the screw; Can not use metal cover and metal container, not to press the start button on the metal table, otherwise it will damage the machine; During the working process, the surface of the induction head should be often touched to check whether it is overheating. If it is hot, it should stop heating and work after cooling. There will be high pressure in the pillow packaging body, and there is electricity on the bottom plate, so attention must be paid to the maintenance to avoid personal danger.