Reciprocating packaging machine product recommendation

Reciprocating packaging machine products are used by many industries, and in today's rapid development of science and technology, products are more and more able to meet the needs of all walks of life, but the use of products can not be sloppy, or need to follow the formal instructions to do!

First, the temperature is too high, the speed is too slow, the heat resistance of the outer coating is poor, and there will be traces of coke wrinkling when sealed. The maintenance method is to accelerate, reduce the temperature, and replace the film material.

The second is the air pressure error, the cylinder swing rod is loose, the heating temperature is low, the hot press roller and the drive roller are not smooth, the maintenance method is to adjust the parallelism, adjust the temperature and pressure and tighten.

Three. If the speed is too fast, the thermal seal effect of the inner layer of the envelope is poor, and the seal will leak or be unstable when the temperature is too low. The maintenance method is to slow down, increase the temperature, and replace the coating material.

And it should be noted that the induction plug must be inserted before power, and the screw must be locked; Do not use metal covers and metal containers, do not press the start button on the metal table, otherwise it will damage the machine; During operation, the surface of the sensor head is often touched to check for overheating. If you find your hands hot, stop the heat and cool down the work. There will be high pressure inside the pillow and an electric current at the bottom. Care must be taken to avoid personal danger.

Fourth, the tool handle is too high or too low, the packaging speed is too fast, the push rod is not synchronized with the tool, the tool will cut the product, the maintenance method is to reduce the packaging speed, adjust the height of the end sealing parts, so that the center of the sealing tool is in the middle of the product height.

Fifth, the color of the film color label is too light, the film drive slips, the color label tracking does not open when the cutting position deviates from the color label, then the maintenance method is to refer to the packaging machine manual, adjust its sensitivity; On the human-machine dialog interface, switch the tracking mode to "Turn Off Tracking".