Do you understand the various lubrication methods of reciprocating packaging machine?

Reciprocating packaging machine Do you know the various lubrication methods of mask packaging machine equipment? With the occurrence of the new coronavirus epidemic this year, the application of vacuum packaging machine for mask packaging has become a trend, so how many lubrication methods do you know about mask packaging machine?

First, manual lubrication

Packaging machinery is mostly used in gear, chain, wire rope and other not commonly used rough machinery and mechanisms, this lubrication device is simple, but the maintenance workload is larger. Because it is manual operation, if you forget to refuel in time, it is easy to cause wear. At the same time, it is easy to dirty the lubricating parts. Manual lubrication devices generally can not adjust the amount of oil, the oil is not uniform, the continuity of the oil and the utilization rate of the oil is poor, so the general manual lubrication is only used for light load or low speed friction.

Two, drop oil lubrication

Drip lubrication is mainly applied to the sliding and rolling bearings, gears, chains, guides, pumps and compressors of packaging machines. Drip lubrication is the use of weight of oil drop by drop to the friction pair, and the drip speed changes with the change of oil level. This lubrication is suitable for small friction pairs that are easily accessible. The structure of the lubrication device is simple, the maintenance workload varies with the number of lubrication points, and the maintenance amount is only less than that of manual lubrication. Because the design of the lubrication device is different, there are automatic opening and closing and there are not automatic opening and closing. Automatic opening and closing lubrication effect is more reliable.

Mask packaging machine

Three, oil splash or oil pool lubrication

Oil splash lubrication or oil pool lubrication is mainly used in packaging machinery and equipment with high degree of automation such as bag vacuum packaging machine and stretch film vacuum packaging machine. The equipment is driven by closed gear chain.

Do you know the various lubrication methods of mask packaging machine equipment? Oil splashing or pool lubrication generally uses high-speed rotating mechanical components to continuously transport oil from a pre-designed oil pool to a variety of interlocking friction pairs. This method of lubrication should only be used on mechanisms that are easily closed. No maintenance required, as long as the specified oil level is maintained, lubrication is very reliable. Because it is sealed, it prevents contamination. It is also circularly lubricated, so it can save lubricating oil and prevent oil leakage. This lubrication is not only more uniform, but also continuous (but varies slightly at different speeds). The flow of oil is generally not adjusted and can only be changed by changing the level of the tank or adding a jet tube to the moving parts.

Four, oil mist lubrication

Oil mist lubrication is mainly used in automatic vacuum packaging machine high-speed rolling bearings and closed gear, chain, slider, guide rail and other parts of the oil mist lubrication device using compressed air to spray out the lubricating oil from the nozzle, so that it atomized and then return to the friction surface, and make it in a saturated state, so that the friction surface attached to a thin layer of oil film to play a lubricating role.

To use this lubrication system must have compressed air facilities, so the application is more complex, but the maintenance is relatively simple. When the equipment is turned on and off, the oil supply is also turned off, so the lubrication system is automatic. Due to the direct oil supply, the lubricating oil is not easy to stain. Its fuel supply can be adjusted.